.

Sunday, September 15, 2013

Ice Galloping

Dealing with Ice Galloping Ice galloping occurs for transmission and distribution lines in many aras of the world. It occurs as the combined result of ice on the conductors and strong winds. While the resulting conductor questions are of relatively enceinte premium, the main result of such motions is electrical not mechanistic failure. Once ice forms on the conductor it usually adheres for the law of continuation of the galloping motions until the wind eventually stops or the air temperature rises. associate techniques have been suggested including the use of drag devices, reduction in sag, and inter-phase place insulators. Davison of Ontario Hydro suggested the first effective means of control in 1939 [10]. He described the concept of providing sufficient phase-to-phase spacing when new lines are designed so that flashovers during galloping are prevented. Calculation of minimum authorisation phase-to-phase spacing is done in terms of galloping ovals based on observati on of ice galloping occurrences. Figure 1 - Ice Galloping ellipse for Phase Spacing Calculations [3] Other methods were developed in accompanying years. A second effective means of galloping control resulted from the studies of galloping at MIT under Richardson in the early 1960s.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
This device, called the wind damper or drag damper, has been refined over the intervening years. A common chord effective means of control the detuning pendulum was developed at Ontario Hydro in the 1970s and became the object of an extensive field investigation by EPRI in the early 1980s. The effectiveness of this device is supported by a thorough statistical analysis of the field d! ata. A fourth method of galloping control by means of each spoilers or VR conductor has also become available in juvenile years. Ice galloping motions occur at one of the important unsloped string modes of the catenary usually the first, second, or third mode. The amplitude of motion associated with the single loop mode is of primary concern, because the...If you penury to amount a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment