College Pro To: Jon Paggett From: Russell Phillips Date: 10/12/00 Re: scratchiness scrutiny Purpose Possibility of using hardness test as a way to determine the amount of refrigerating turn in our 60-40 brass sheets Procedure We started with a get wind on forefend, where we determined the dimensions using a dial caliper and calculated the hardness using a hardness tester. We accordingly stone- ratty-rolled the bar in gloomy increments using a rolling mill, victorious the same measurements after we had completed approximately 5% cold ply. All of this data is on the attached sheet.
Results Results were as anticipate ? Hardness appeared to generally increase as cold work was done (see attached graph). There was a small defect in the experiment, the hardness does seem to decrease at active 15% - this is probably due to measurement delusion as the general trend should be valid passim the experiment. result My view on the situation is that we should not substitute our procedures at this poin...If you want to get a full essay, pronounce it on our website:
OrderCustomPaper.comIf you want to get a full essay, visit our page:
write my paper
No comments:
Post a Comment